3D Printer Parts and Accessories, FYSETC 3D Printer Limit Switch Mechanical Switch Module Endstops Switch with 3 Pins 39.4 inch Cable for Ramps RepRap Tevo Tornado- 3 Pcs

Specification:

1. Max Voltage: 250V
2. Max Current: 5A
3. Board size: 20 x 20 x 7 mm/ 0.8 x 0.8 x 0.3 inch
4. Cable length: 1 meter (39.3 inch)

Package includes:
3 x 3D Printer limit switch
3 x 3 Pins Cables

Product Features

  • Original Tevo 3D Printer Parts, Optical Endstop switch with 1M Photoelectric Light Control;
  • Endstops for 3D Printer: usedd for Tevo, if you want to in all creality 3D Printer, CR -10 CR 10S S4 ,S5, please research another item: B07PKPDMRL ;
  • Must 3D Printer Limits: With trigger indicator, 3 Pin N/O N/C control, easy to use Micro Switch;
  • Warm Tips: Generally, the printer DIY system need at least three optical switches;
  • After-sales guarantee: we are responsable for our every product, if you received desfective or did not work well, please feel free to contact us, we will resend you replacement for free or refund you.

Visit The Website For More Information…

Published by

Best 3D Printer

3D Printing. The next Goldrush is on it´s way. Inside information on how to start printing in 3D, where to buy Printers, how to use them, and the newest Pictures and reviews of available 3D Printers.

2 thoughts on “3D Printer Parts and Accessories, FYSETC 3D Printer Limit Switch Mechanical Switch Module Endstops Switch with 3 Pins 39.4 inch Cable for Ramps RepRap Tevo Tornado- 3 Pcs”

  1. Confirmed – Will Not Work for Ender 3 And it’s not just “a little rewire” to fix, as another poster suggested. Ender requires 1 and 3 to have no resistance when switch is open, resistance when switch is closed. This product has resistance when open and closed between pins 1 and 3. Pins 1 and 3 run the LED light, which Ender doesn’t support.But it’s worse than that. There’s no rewire that will make this work. Pins 1 and 2 are the closest – they give resistance when the switch is open, no resistance when closed – the…

  2. Does not work as advertised The stops did not work as advertised. The pictures show them working with the stock two wire set up on the Creality machines. I installed the stop on the X-axis on my Ender-3 and it was in the normally open position and it never homed the Z axis. I tested the stop I purchased and it was putting out 2.75 volts no matter if the switch was opened or closed. I tested the stock stop and it worked as intended.I ended up desoldering the switch from the stop I purchased and swapped it…

Leave a Reply

Your email address will not be published. Required fields are marked *