BIQU 3D Printer Part SKR V1.1 32-Bit with ARM CPU Control Board Open Source Smoothieboard Support TMC2130 TMC2208 Driver 12864 LCD

product Parameter
Microprocessor: ARM Cortex-M3 CPU
Input voltage: DC12V-DC24V  5A-15A
Motor Driver: Supports TMC2208, TMC2130, LV8729, DRV8825, A4988 Etc., can be externally connected to the motor drive
Motor drive interface: X, Y, Z, E0, E1, five channels (each channel has a re-expandable interface), up to 256 subdivisions
Temperature sensor interface: TH0, TH1, TB, 3 channels 100K NTC (thermal resistance) Display: 2.8 inch TFT, 3.5 inch TFT,LCD12864
PC communication interface: square USB, easy to plug and unplug, communication baud rate 115200
Support file format: G-code
Support machine structure: XYZ, delta, kossel, Ultimaker, corexy
Recommended software: Cura, Simplify3D, pronterface, Repetier-host, Makerware

Packing List:
1*SKR Board 1*cable

Product Features

  • ARM-class Cortex-M3 series LPC1768 master chip with 32-bit main frequency 100M,Can be greatly improved
  • Acceptable 24V input, the hot bed current can be reduced to 1/4 under the same power, effectively solving the heating problem of the hot bed MOS tube
  • Upgrade the firmware by SD card, which is easy and convenient to operate
  • Use the configuration file to set the driving current mode, avoid manual adjustment of the current to cause the burned drive, convenient, safe and reliable
  • Support functions:  Non-trace resumption after power off, run out filament ,and auto shut down

Visit The Website For More Information…

Published by

Best 3D Printer

3D Printing. The next Goldrush is on it´s way. Inside information on how to start printing in 3D, where to buy Printers, how to use them, and the newest Pictures and reviews of available 3D Printers.

Leave a Reply

Your email address will not be published. Required fields are marked *