The circuit wiring of CR-10 S4, CR-10 S5, CR 20, CR20 Pro are different from the manual, while Ender 3,Ender 3 Pro,Ender 5, CR-10 are same as the manual.
1. Use USB cable to connect CR-10 S4, CR-10 S5, CR 20, CR20 Pro with computer to flash the firmware, the ISP connector and ISP pinboard are not needed.
2. No need to plug the pinboard A to mainboard of CR-10 S4, CR-10 S5, CR 20, CR20 Pro, just insert the connectors into the mainboard D11 pins and unplug Z limit switch then insert the connectors into the Z port.
An auto leveling sensor for 3D Printer based on open-source.
Simple, high-quality, smart and precise.
Used for 3D Printer for CR-10/for CR-10SPRO/ENDER-3,
Item type:Auto Press Bed Leveling Kit
Color: As pictures.
1 set of Leveling Kit
1. Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you!
2. Please allow 1-3cm measuring deviation due to manual measurement.
If the BL touch doesn’t work well. you can reference the website: www.antclabs.com/wiring3
- Application: Suitable for Ender-3 / Ender-3s / Ender-3 Pro /Ender 5 /CR-10 / CR-10S/ CR 10S4/ CR 10S5/ CR-20 / CR-20 Pro and so on 3D Printer(Note: Please flash the firmware first, with ISP cable to connetct computer and printer while CR 10Scan be connected directly to computer by USB)
- Easy to Use: This auto bed leveling sensor make it easier to levelling the hot bed, which can precisely measure the tilt of Bed surface. Bed leveling is not a problem anymore.
- Intelligence, self – check and alarm. Function of auto leveling is adopted to make it easier to use and to increase the success rate of shaping.
- Firmware:Please move to the Creality Official Website to download: https://creality3d.cn/products/
- Packing includes: 1 set of auto bed Leveling Kit (as image shows). If you have any question about this product, please feel free to contact us!